![]() Allow the cement to harden for 30 minutes, or according to the manufacturer's instructions on the bag. Pour the entire bag into the hole in which the play structure's leg stands. Mix the concrete one bag at a time, until the concrete is like a thick, stony toothpaste. Mix one bag of concrete in the plastic tub for each footing hole. Recheck the structure with the level to make sure that it is still level, adjusting the depth of any footing hole as necessary. ![]() Move the play structure back into place, and set one leg into each of the footing holes. In an area of the country where the ground freezes during the winter, the footing should be 24 inches deep. Move the play structure over a few feet to gain access to the footing locations.ĭig a hole at least 18 inches deep at each of the footing locations. Each of these locations will be a footing for the play structure. Mark the locations of the legs on the ground with stakes, or by removing a small chunk of the sod with the shovel. Make sure that the planned installation will work in the area you have selected before digging holes in the ground.Īnchoring the Structure with Concrete Footings Step back, and view the playset from 360 degrees. Visually verify that the installation can be completed. The play structure should now rest level on the ground. This is the length by which the legs on the uphill side of the structure will be shortened.Ĭut off the legs on the uphill side of the structure with the sawsall by the amount measured in the previous step.Īfter shortening the uphill legs, remove the bricks from all the legs. Measure the distance that the legs on the downhill side of the structure are above ground. Lift the legs on the downhill side of the structure as needed to make the structure rest level and plumb. Any horizontal supports between the legs should also be level. The main beam must be level in all directions, and must be centered between the A-frame legs. Level the play structure by placing bricks or cinder blocks under the sets of legs that are on the downhill side of the slope. Evaluate the setting, and visually identify that the structure's legs can be buried into the ground in the proposed location. Position the play structure on the sloping yard in the proposed location. The sets of legs are joined at their apex by a central beam that runs the length of the play structure. ![]() With most playsets, the main frame is composed of two or three sets of legs bolted together into an A-frame. Laying Out the Play StructureĪssemble the play structure's main frame according to the manufacturer's instructions. ![]() For the structure to be stable, the legs should be cemented in the ground. Do not rely on a mechanical anchor when building a playset on a sloping yard. Some metal playset structures are sold with stakes that anchor the legs into the ground. Do not install this type of playset on sloping ground. These playsets are designed to rest on top of the ground rather than be anchored with footings into the ground. Some wooden playsets have legs that are designed like inverted Ts rather than an A-frame.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |